Commodore 1:5

Remember this...

Progress is being made.

Paint area is large so you can split up the work

and concentrate on the finish.

Vast areas mean a lot of paint.

 and the results are good!

colours have changed slightly from the render. But all will work out.

.RSG. Stage 5 Spec R - Test

Testing the new 50mm low grip front tyres and refined parts has been a huge success.

.RSG. Stage 5 Spec R

.RSG. Design Stage 5 Spec R. 1/5th scale Rear Wheel Drive Drift Chassis.

Test & Demonstration

TEST ... Had a couple of friends over for a demo run.

FIFTH TEST

Tyres and Lock... YEAH BABY! Thats what I'm talking about. So Happy!

Looks are awesome too.

Even the printed PLA is soft, but the surface I was running on for 45 minutes resulted in adequate tyre wear. $1.99 per tyre. not bad. Change in Camber required. I think I'll make these thinner also. down to 52mm from 65. I have adequate grip running on 20mm of the tyre and it will increase lock up front also.

My prototypes are awesome. i knew the setting on the printer were not right for this one. With only 1.2mm wall width I knew any impact was going to be touch and go.

I have already revised the TE37 and have a spare as printed today.

.RSG. Prototypes

It's all about the angle and the dangle.

Prototype Progress

Progress is continuing on the 1/5 RWD project.